Untitled 1
HOME STORE GRAPHICS MACHINE SHOP DYNO SERVICES CUSTOMERS PROJECTS

Block Work 

BORE BLOCK .030                            225.00 INSTALL LIFTER BUSHINGS       1200.00
BORE ADDITIONAL .030                 150.00 JET SPRAY BLOCK                         75.00
HONE                                                    175.00  SOLVENT WASH BLOCK                50.00
HONE W/PLATE                                  275.00 REMOVE PLUGS                             75.00/HR
DECK BLOCK (YOU CHECK)              125.00 CLEARANCE FOR RODS              1255.00/HR
DECK BLOCK (WE CHECK)               200.00 RESTRICT OIL                                   25.00
SQUARE W/ BHJ FIXTURE          ADD  50.00 INSTALL OIL SCREENS                   35.00
O-RING BLOCK                                    400.00 INSTALL CAM BEARINGS              100.00
CUT TOP OF BLOCK                            125.00 FREEZE PLUGS INSTALLED             80.00

                                               

 Square decking a Dart 351w ford block on our Peterson STC 361 CBN surface mill.  All blocks are set up on our BHJ fixture.         This assures that all milling is done on plane with the crankshaft centerline

                          

                  Preparing a Dart small block for hone finishing cylinder walls on our Sunnen CV616

           We have a huge selection of deck torque plates

All honing is done in precise incremental steps, each with different grit stones or diamonds to give a precision plateau finish.